Tools

M10 hand tap with a Würth ratchet tap holder, to re-thread damaged T-nuts on your climbing wall by hand. The ratchet works in tight spots, under a roof or behind a volume, with full control on the thread.

M10 machine tap for cleaning out and re-threading T-nuts on climbing walls. A crossed or clogged T-nut gets back into service in seconds, without opening the panel. Mounts on a drill for speed.

8 mm T-handle hex key with three drive ends, sized for the M10 socket head bolts used on climbing holds. Use the long end to spin the bolt in fast, then the T-handle for the final tightening torque.

Würth Torx T25 bit, 70 mm long, made to drive our T25 wood screws into screw-on holds and volumes. The compact 70 mm length keeps the drill close to the hold for precise setting. Fits any drill or impact driver, or our magnetic bit holder.

Matching screws: Wood Screws.

Würth Torx T20 bit, 70 mm long, made to drive our T20 wood screws into screw-on holds and volumes. The compact 70 mm length keeps the drill close to the hold for precise setting. Fits any drill or impact driver, or our magnetic bit holder.

Matching screws: Wood Screws.

Würth Torx T25 bit, 120 mm long, made to drive our T25 wood screws into screw-on holds and volumes. The 120 mm length reaches screws set deep in a volume or a big screw-on. Fits any drill or impact driver, or our magnetic bit holder.

Matching screws: Wood Screws.

Würth Torx T20 bit, 120 mm long, made to drive our T20 wood screws into screw-on holds and volumes. The 120 mm length reaches screws set deep in a volume or a big screw-on. Fits any drill or impact driver, or our magnetic bit holder.

Matching screws: Wood Screws.

Würth magnetic bit holder for drills and impact drivers. The magnet holds the screw on the bit, so you can place a screw-on with one hand while the other holds the wall. Takes our Torx T20 and T25 bits.